Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Repair for Tacony Homeowners
Water is the slowest and most expensive problem a chimney faces in Tacony. It gets into cracked mortar, soaks into brick that’s already spalling, and rusts the steel that holds a cap in place. What starts as a hairline crack near the crown becomes a rebuild if you leave it through two or three freeze-thaw cycles. Our technicians have up to 13 years of experience diagnosing exactly that kind of damage, and we work with professional-grade materials from names like HeatShield, DuraFlex, and Gelco. We diagnose the system, not just clean the flue. Call (833) 370-3312 and we’ll set up a free estimate. Same-day repair is available.
What Our Chimney Repair Service Includes
Chimney repair is the catch-all for anything structural or water-related in a chimney system: the masonry, the crown, the flashing, the liner, and the firebox. It’s separate from a routine sweep, which only clears the flue. Here’s how we handle each type of repair in Tacony.
Mortar Repointing
Mortar joints hold brick together, and over time weather pulls the mortar back and leaves the brick loose. Repointing means grinding out the failing joints and packing them with fresh mortar matched to the original mix. We repoint whole chimney stacks and spot-repair individual joint lines, depending on how far the damage has spread.

Spalling Brick Repair
Spalling is when the face of a brick flakes off, usually because moisture got inside and expanded during a freeze. Once the face is gone, that brick keeps absorbing water and the damage spreads to its neighbors. We replace spalled brick with matching units and then get a waterproofing layer over the repair so it doesn’t happen again.

Chimney Waterproofing
Waterproofing is a breathable sealant applied to the exterior masonry that keeps rain out while letting moisture inside escape. Any chimney that’s had repointing or brick replacement needs it, and honestly, most standing chimneys in Tacony could use it. We apply waterproofing after repair work settles so it protects the new mortar and brick rather than trapping moisture under a seal.

Flashing Repair
Flashing is the metal where the chimney meets the roofline, and it’s the single most common source of roof leaks around a chimney. When the flashing pulls away or rusts through, water runs down the chimney and into the attic instead of off the roof. We reseat flashing, replace failed sections, and check the counter-flashing where it ties into the roof so the joint is actually weathertight.
Chimney Rebuilding
When a chimney has leaned, lost enough brick that the stack is unstable, or failed at the crown, rebuilding the damaged section is the honest answer. A rebuild means taking the chimney down to a solid base and laying new masonry back up, usually from the roofline. We rebuild chimney stacks and crowns, and we’re capable of the full job, not just surface-level cleanup that hides the problem.
Tuckpointing
Tuckpointing refines the look and strength of mortar joints, and it’s what we do once a repointing job is complete and the mortar has cured. It gives the joints a clean, uniform finish and tightens the seal at the surface. On a chimney where the joints are still sound but worn, tuckpointing alone can buy years before a full repoint is needed.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Repair
We work with HeatShield, the professional-grade liner resurfacing system, and we know what its limits are. HeatShield is a repair pathway before full replacement, and we lean on it when the flue is structurally sound but worn, because it can extend chimney life without a rebuild. We also install DuraFlex flexible liner systems, which is what we reach for in older or non-standard flue configurations where rigid liner won’t fit.
On the component side, we supply and install Famco and Copperfield products, brands used by professional chimney contractors around the country. That covers caps, dampers, and the hardware that finishes a job properly. Whether you have a HeatShield-resurfaced flue, a DuraFlex liner, or any other make, we can help, and we’ll tell you plainly if a repair you’ve been quoted is the right one or not.
Signs You Need Chimney Repair Right Now
- White or crumbling stains on the masonry. That chalky residue is called efflorescence, and it means water is moving through the brick. The water is dissolving salts inside the masonry and pushing them to the surface, so the chimney is already taking on moisture.
- Cracked or missing pieces of mortar between bricks. Joints that have pulled back more than about the depth of a fingernail are no longer holding the brick. When the mortar fails, the brick starts to shift, and that’s when a repointing job turns into a rebuild if it’s left alone.
- Rust streaks or water staining on the roof around the chimney. This usually points to failed flashing or a crown that isn’t shedding water. It’s the kind of leak that shows up as an attic stain weeks later, so getting it looked at early saves the ceiling and the framing.
- A chunk of brick or mortar on the roof or ground below the chimney. If material has fallen, the stack has lost enough of its structure that even a small wind gust can make it worse. That’s a get-it-checked-first situation, not a next-season one.
- A chimney crown that’s cracked or pulling away from the flue. The crown is the flat top that keeps rain out of the masonry below, and once it cracks, water runs straight down into the stack. A crown repair now is far cheaper than rebuilding a water-damaged chimney later.
Our Chimney Repair Process – Step by Step
- 1
Inspection and diagnosis. We look at the whole system, from cap to firebox, and we check the flue with a camera where it’s warranted. You get a plain explanation of what we found and photos you can see for yourself, not just a verbal “you need work.”
- 2
Written estimate before any work. Every job is priced per job, and the written estimate sets the final price. We don’t hand you a number over the phone and then change it in the driveway. You know what the repair costs before anyone starts.
- 3
Repair scope matched to the damage. If mortar is the only problem, we repoint. If the flue is the problem, we look at HeatShield resurfacing before recommending full relining. The scope follows the evidence, not the upsell.
- 4
Repair with professional-grade materials. We install DuraFlex, HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield products as the job calls for them. Using the right material for the right application is what keeps a chimney repair from failing again a few seasons later.
- 5
Final walk-through and cleanup. We show you what was done, confirm the drainage and seal work is right, and leave the work area as clean as we found it. If something can wait, we tell you what it is and when it should be handled.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Repair Cost in Tacony?
Chimney repair in Tacony typically runs from about $350 to $1,200 for most common repairs, depending on the scope. A typical mortar repointing job on a single chimney stack runs $450 to $900 depending on how many joints and how much height is involved. Spalling brick repair with matching units and waterproofing usually lands in the $600 to $1,200 range. Flashing repair is often the smaller job, roughly $350 to $650. A full chimney rebuild is a bigger number, often several thousand dollars, because it involves new masonry and a new crown.
What moves the price: the height of the chimney, how much masonry is actually failing versus just stained, whether scaffolding is needed, and whether the repair crosses from the flue into the firebox. The way to avoid overpaying is to ask for camera evidence and a written scope that lists what’s being replaced, not just “repair chimney.” Nothing is recommended without camera evidence you can see for yourself.
Every estimate is free, and the written estimate sets the final price before work starts. If part of the job can safely wait, we’ll tell you which part and how long you have. Call (833) 370-3312 for an exact quote.
Chimney Repair Near Tacony – Our Service Area
We handle chimney repair across Tacony and the surrounding neighborhoods, including South Philadelphia, Mayfair, Oxford Circle, Holmesburg, Frankford, Rhawnhurst, Fox Chase, Cheltenham Village, Olney, Torresdale, and Kensington. Most jobs in and around Tacony get a next-day appointment for a free estimate, and we’ll confirm a window when you call. For broader service, see our chimney sweep in Tacony, and if you’re in South Philadelphia or Mayfair, we have dedicated pages for those areas too.
Serving Tacony, PA – Our Local Coverage Area
We serve Tacony and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Repair in Tacony
Chimney repair covers the structural and water-related work on a chimney system, including masonry, mortar, the crown, flashing, the liner, and the firebox. It’s distinct from sweeping, which only removes creosote and debris from the flue. If you’re seeing cracked mortar, water stains, or a chip of brick on the roof, that’s repair territory, not cleaning territory. Call (833) 370-3312 for a free estimate.
Most repairs take one to two days for repointing, tuckpointing, flashing, or waterproofing. A spalling brick repair with matching units can take a bit longer if we’re waiting on material. A full chimney rebuild is a multi-day job, often three to five days depending on height and access. We’ll give you a realistic timeline with the written estimate.
Most chimney repairs in Tacony fall between $350 and $1,200, with a full rebuild running higher depending on scope. Repointing, spalling repair, waterproofing, and flashing are typically on the lower end of that range, and a rebuild is where the price climbs. The written estimate sets the final price, and there’s no charge for the estimate itself. Call (833) 370-3312 for an exact quote.
Yes, we work with HeatShield liner resurfacing and install DuraFlex flexible liner systems for older or non-standard flue configurations. We also supply and install Famco and Copperfield components, so the job is finished with the right hardware, not whatever’s on hand. Whether you have HeatShield, DuraFlex, or another make, we can help, and we’ll tell you if the repair is the right one.
Same-day repair is available when the job allows it. We answer 24/7, and fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed on Saturday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Warranty terms depend on the repair, so we put them in writing in the estimate before work starts. Masonry repairs, liner work, and cap and crown work each carry different expectations, and having it in the document means there’s no guessing later. Ask us to spell it out for your specific job when you call.
Clear access to the fireplace and the roof path if you can, and move anything breakable away from the hearth. Let us know about any pets, and if you have a gas fireplace, tell us the make when you book so we bring the right parts. That’s it; we handle the rest and clean up after.
Schedule Your Chimney Repair Service in Tacony Today
From annual sweep to full liner rebuild, one specialist, one call. Call (833) 370-3312 and we’ll set up a free, no-obligation estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Cap, crown, liner, firebox, the complete chimney, covered.
Written by the team at Chimney Sweep Tacony.