Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Rhawnhurst
A missing cap or a cracked crown in Rhawnhurst usually shows up the same way: a damp stain on a ceiling, a flue that smells of rain, or a chunk of brick on the roof. We handle chimney cap and crown work on the brick rowhouses and twins that make up most of this neighborhood, and we know how these mid-century chimneys were built because we see the same build repeated block after block. Call (833) 370-3312 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Why Rhawnhurst Homeowners Call Chimney Sweep Tacony for Chimney Cap & Crown
Rhawnhurst sits within our primary service area, so getting a technician to a rowhouse near Castor Avenue or along the Bustleton Avenue corridor is a straightforward trip, not a cross-town haul. Our technicians have up to 13 years of experience, and that time shows up in the details: reading a crown for spalling versus surface wear, sizing a cap to the actual flue opening, and knowing when a tile liner can be saved instead of replaced.
We work with professional-grade brands like Gelco, Olympia Chimney, Famco, and Copperfield, which means the cap or crown going onto your chimney is a real component spec’d for the job, not a generic piece from a big-box shelf. We don’t claim to stock parts locally; we source the right component and schedule the installation. Turnaround for standard cap and crown work is typically within days of the written estimate, not weeks. If you want a sweep, a crown repair, or a liner checked while we’re up there, that’s one call to one specialist.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Rhawnhurst
Cap and crown work is the front line of chimney protection on Rhawnhurst’s 1950s and 1960s brick chimneys. Here’s what we do and how it applies to the homes on your block.
Cap Installation in Rhawnhurst
Many Rhawnhurst chimneys were built without a factory cap, and decades of rain have gone straight down the flue. We install a correctly sized cap that keeps water, leaves, and twigs out while letting exhaust escape. On the tree-lined blocks around Rhawnhurst Elementary and the residential streets off Rhawn Street, a mesh-sided cap also stops the leaf litter that chokes draft.

Cap Replacement in Rhawnhurst
When an older cap is rusted through, bent, or the wrong size, replacement saves the flue below it from further water damage. We match the new cap to the flue count and opening so it seats properly and seals at the crown. If a neighboring twin has the same cap, it’s usually failing on the same timeline, so we check that too.

Crown Repair in Rhawnhurst
The crown is the concrete or mortar cap at the top of the chimney, and it takes the brunt of Philadelphia’s freeze-thaw cycles. Soft mid-century brick and mortar spall and crack when water gets in, then the crack leaks at the flashing. We repair crowns that are structurally sound and rebuild ones that aren’t, and we show you the camera evidence before recommending either.

Crown Coating in Rhawnhurst
For a crown that’s sound but showing surface wear, a flexible crown coating seals hairline cracks and buys years before a rebuild is needed. It’s a practical middle step on a chimney that doesn’t yet justify full reconstruction. We only recommend coating when the crown underneath is intact, not as a cover-up for a failing crown.
For a multi-flue chimney serving both a fireplace and a furnace, or a custom cap sized to an irregular opening, our chimney cap & crown team handles the measurement and fabrication. If you’re comparing this against a full reline, the camera inspection tells you which one you actually need.
Trusted Brands We Service in Rhawnhurst
Cap and crown components aren’t the only thing we install; we work across the full chimney system, which is why the brands matter. We use Gelco and Olympia Chimney components for caps and crowns, Famco and Copperfield for the fittings that go with them, and HeatShield for liner resurfacing when a flue can be saved instead of replaced. When a cap install uncovers a failed liner, we can handle the DuraFlex flexible liner work in the same visit rather than sending you to a second contractor. That scope is the reason a lot of Rhawnhurst homeowners keep one number for the whole chimney.
Common Chimney Cap & Crown Problems We See in Rhawnhurst Homes
- Missing factory caps on 1950s and 1960s chimneys. Many exterior masonry chimneys here were finished without a cap, so rain and leaf litter have fed an already aging terracotta liner for decades. That’s the single most common cause of a wet flue we find in Rhawnhurst.
- Spalled and cracked crowns from freeze-thaw cycles. Philadelphia’s winters push water into soft mid-century brick and mortar, then freeze and split it. The crown face cracks, water gets behind the flashing, and the leak shows up as a stain inside, not on the roof.
- Tree-lined blocks clogging caps and crowns. The heavily wooded streets around Rhawnhurst mean flat or mesh caps collect twigs and leaves, which chokes draft on appliances vented into older stacks. A cap that’s correctly sized and screened keeps that out.
- Appliances vented into stacks they were never designed for. On some Rhawnhurst blocks, a gas furnace or water heater was tied into a flue sized for an old coal or oil appliance. The stack drafts poorly, and a damaged crown or open flue makes it worse.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Rhawnhurst, PA
Pricing is per job by written estimate, and the estimate is free. A typical cap installation in Rhawnhurst runs $250 – $550 depending on flue count and cap style. A standard cap replacement runs $200 – $450. Crown repair runs $300 – $700; a crown rebuild runs $600 – $1,400; crown coating runs $250 – $600. Multi-flue caps and custom caps run higher, typically $500 – $1,200, because they’re sized and fabricated to the opening. The written estimate sets the final price, and we show you the camera evidence before recommending any work above a simple cap. Nothing gets added without a reason you can see on-screen.
We Also Serve Cities Near Rhawnhurst
We work throughout Rhawnhurst and the surrounding neighborhoods, including Mayfair, Holmesburg, Fox Chase, and Northeast Philadelphia. If you’re on a block just over the line, call (833) 370-3312 and we’ll confirm coverage before scheduling. Our service area for Rhawnhurst covers the whole neighborhood and nearby streets where the housing stock is the same mid-century brick.
Serving Rhawnhurst, PA – Our Local Coverage Area
We serve Rhawnhurst and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Rhawnhurst
Yes. A cap is the single cheapest protection for an uncapped flue, and a Rhawnhurst rowhouse that’s gone decades without one has likely taken water into its clay tile liner the whole time. The cap keeps rain, twigs, and animals out while letting exhaust escape. We’ll run a camera to check what the flue looks like before recommending one. Call (833) 370-3312 for a free estimate.
It depends on how deep the damage goes, and the camera inspection answers that question on-screen. A sound crown with hairline surface cracks can be coated; a crown that’s spalled through or pulling away from the flue needs rebuilding. We don’t coat over a failing crown to save a step. Call (833) 370-3312 for a free estimate.
You see the camera evidence before anything is recommended. On a typical mid-century Rhawnhurst rowhouse, a pro runs a camera down the flue, shows the homeowner the cracked tile and spalling mortar, and replaces the crown and fits a cap rather than jumping to a full reline. Ask to see the footage and ask what the flue looks like without the cap. If the answer is a reline, the footage should show it. Call (833) 370-3312 for a free estimate.
Yes. A compromised crown lets water in, and a missing cap lets leaf litter and debris block the flue opening, both of which reduce draft on appliances vented into the stack. On Rhawnhurst blocks where a furnace was tied into an old flue, the effect is more pronounced. Call (833) 370-3312 for a free estimate.
Usually, yes. Because so many Rhawnhurst rowhouses and twins went up in the same few years, the exteriors on a block tend to share one chimney build. A missing original cap or a spalled crown on one house predicts the same pattern two doors down, and a reputable pro will scope neighbors’ rooflines before quoting. That’s part of how we read a Rhawnhurst block. Call (833) 370-3312 for a free estimate.
Book Your Cap or Crown Estimate
Whether it’s a missing cap on a Rhawnhurst twin, a spalled crown that’s letting water into the flashing, or a multi-flue chimney that needs a custom cap, we’ll come out, run the camera, and show you what we find before recommending anything. Cap, crown, liner, and firebox are all handled by one specialist. Call (833) 370-3312 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Tacony.