Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across Rhawnhurst
If your fireplace won’t draw, your crown is shedding brick, or you’ve been told you need a full reline and want a second opinion, call Chimney Sweep Tacony at (833) 370-3312. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. We work Rhawnhurst chimneys constantly, and we know what these blocks are built from: 1950s and 60s brick rowhouses and twins, exterior masonry stacks, and flues that have been quietly aging for the better part of a lifetime. That matters, because chimney repair in Rhawnhurst is rarely a mystery. The houses repeat. So do the failures.
Why Rhawnhurst Homeowners Call Chimney Sweep Tacony for Chimney Repair
Most chimney problems in Rhawnhurst aren’t exotic. They’re the ordinary, predictable wear of mid-century construction in Philadelphia’s freeze-thaw winters and humid summers. That combination works on soft brick and mortar joints every year, and after sixty or seventy winters the damage shows up in the same places.
We keep our work measurable in a way homeowners can check. We diagnose the whole system, not just the flue: cap, crown, mortar joints, flashing, liner, firebox. And when we recommend a repair, we show you the camera footage that justifies it. If a pro tells you from the ground that you need a full rebuild, ask to see inside the flue. If they can’t show you, you don’t have a diagnosis yet.
Our technicians have up to 13 years of experience, and the roster of professionals we connect you with is licensed and insured as the state requires. A written, flat-price sweep is agreed before anything is booked, so the number doesn’t move once the work starts. That’s how it should go everywhere. In Rhawnhurst, it’s how we do it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Repair Services in Rhawnhurst
Six repair lines, one specialist from cap to firebox. Here’s what each one actually means for a Rhawnhurst chimney, and how we decide which one you need.
Mortar Repointing
Repointing is the work of replacing the failed mortar between brick courses while the brick itself is still sound. On Rhawnhurst chimneys, the joints above the roofline take the worst of it, and a soft, sandy joint lets water in where it can freeze, expand, and open the joint further. Repointing is often the difference between a chimney that lasts another thirty years and a crown that starts dropping brick.

Spalling Brick Repair
Spalling is when the face of a brick flakes off and exposes the softer interior, which then absorbs water and fails faster. It’s common on the mid-century stacks here because those bricks were softer than what came later, and decades of freeze-thaw have done their work. We replace the spalled units rather than parging over them, since a patch over a failing brick just buys a season or two.

Chimney Waterproofing
A breathable masonry water repellent slows water absorption without trapping moisture inside the brick. On Rhawnhurst’s tree-lined blocks, moisture plus leaf debris plus shade is a slow recipe for mortar failure, and a waterproofing coat after a repointing job is the cheap insurance. We don’t waterproof a chimney with active leaks until the source is found, though. Sealing over a flashing leak just hides it.

Flashing Repair
Flashing is the metal that keeps the roof-to-chimney joint watertight, and on these rowhouses it’s often original or patched more than once. A failed flashing shows up as staining on the ceiling near the chimney chase or rust streaks down the masonry, and it’s frequently mistaken for a failing crown. We check both. This is the repair most often skipped because it doesn’t look dramatic, and the one that does the most hidden damage when it’s missed.
Trusted Brands We Service in Rhawnhurst
We work with professional-grade brands because chimney repair done with the wrong material is worse than no repair. For liner resurfacing we use HeatShield, a proven option that gets a failing flue back into service without the cost of a full replacement. For a full reline, we install DuraFlex flexible liner systems, which are the standard solution on older or non-standard flue configurations where a rigid liner simply won’t fit. We also supply and install Gelco and Olympia Chimney components, and Famco and Copperfield parts for caps, dampers and related hardware. These are names professional chimney contractors use nationwide, not the stock a general handyman picks up locally. We don’t stock parts on a truck or in a warehouse. Everything is specified for your flue and your measurements, which slows the job by a day or two and gets it right.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Repair Problems We See in Rhawnhurst Homes
The recurring failures in this neighborhood come down to four patterns. If you recognize yours, you’re not imagining it.
- End-of-life clay-tile liners. The original terracotta flue tile has cracked or spalled after decades of freeze-thaw, and the gaps at the joints let exhaust and heat escape into the masonry. Some of these flues were never properly sized for the appliance now connected to them, especially where an oil or coal furnace was converted to gas decades ago.
- Missing chimney caps. A great many of these houses never got a cap, and rain runs straight down the flue onto the smoke shelf and damper. Leaves and twigs off the tree-lined block then clog the crown, so water sits where it shouldn’t and the soft brick above the roofline gives up faster.
- Crumbling crowns and open mortar joints. The crown is the concrete slab at the top of the chimney, and when it cracks, water runs into the masonry. On a mid-century Rhawnhurst chimney, a failed crown plus an open joint is the start of every other problem on this list.
- Flashing that was never right. These rowhouse chimneys sit tight against a steep roof, and original flashing has often been patched once too many times. A leak that shows up three feet from the chimney is usually a flashing problem, not a crown problem.
There’s a bigger pattern underneath all four. Rhawnhurst’s rowhouses and twins went up in the same few mid-century building years, so liners tend to hit end-of-life on whole blocks at once. When a clay-tile flue fails on one house, the technician can predict the same cracked-tile pattern two doors down. That’s not a sales pitch. It’s why we run a Level 2 camera inspection as a matter of course, and why we don’t quote a reline from the ground. You see the footage before anything is recommended, and we say plainly when a chimney can safely wait until spring.
Here’s how a typical job goes, because it’s the same story most of the time. A homeowner lights the fireplace and gets a weak draft and a smoky smell, or the gas furnace flue won’t pull. A camera run down the flue shows what the clay tile has become: hairline cracks, spalled edges, gaps at the joints where the soft brick has given up. The usual cause is an original unlined or clay-tile flue with no cap, so rain, leaves and twigs have been working on the mortar for years. A qualified pro repoints the crown and mortar joints, repairs or replaces the liner with a listed system such as DuraFlex or HeatShield, fits a cap, and leaves you with the photo report. That report is yours. Our chimney repair team works to that standard on every Rhawnhurst job.
Pricing for Chimney Repair in Rhawnhurst, PA
Typical Rhawnhurst costs for the common repairs, based on what these jobs usually run on mid-century rowhouse and twin chimneys. A typical mortar repointing on a chimney above the roofline runs $400 to $900. Spalling brick repair with replacement units runs $350 to $750. Chimney waterproofing runs $250 to $500. Flashing repair runs $250 to $600. A crown rebuild runs $400 to $800. A full chimney rebuild, when the stack above the roofline is beyond repair, runs $3,500 to $8,000. Liner work is quoted separately: HeatShield resurfacing is a repair pathway that can extend the life of a chimney without the cost of a complete rebuild, and a full DuraFlex reline is quoted against your measured flue. These are estimates, and the written estimate you receive sets the final price. A camera inspection and photo report come with the estimate, and the estimate itself is free.
We Also Serve Cities Near Rhawnhurst
The same mid-century rowhouse and twin chimneys repeat across the Northeast, so we cover the neighborhoods around Rhawnhurst as well: Mayfair, Holmesburg, Fox Chase, and the wider Northeast Philadelphia area. Same camera-first standard, same written estimates, same flat price agreed before booking. If you’re just over the line from Rhawnhurst, we can still help.
Serving Rhawnhurst, PA – Our Local Coverage Area
We serve Rhawnhurst and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Repair in Rhawnhurst
No, but it’s a fair reason to have yours looked at. Whole blocks here were built in the same few years, so if one neighbor’s clay tile has cracked, the odds are good your flue is the same vintage and may show the same pattern. That’s still a maybe, not a certainty. A camera run down your flue settles it in twenty minutes. Call (833) 370-3312 for a free estimate with the footage included.
It can be, and it’s common in these houses. Flues were sized and lined for coal or oil, and a gas furnace vented into an oversized, unlined flue can cool too quickly, condense, and corrode the masonry from the inside. The flue also needs to be correctly sized for the appliance. A camera inspection answers both questions without opening the wall. Call (833) 370-3312 to book one.
You ask to see the inside of the flue on camera. Anyone recommending a reline or rebuild should have interior footage showing the cracked tile, spalled edges, or open joints, and that footage should be yours to keep. If a contractor quotes a rebuild from the ground with no camera evidence, get a second opinion. We don’t recommend work we can’t show you. Call (833) 370-3312 and we’ll start with the inspection.
Usually repointing and a crown repair, not a rebuild. A crumbly crown is the concrete slab at the top, and it can be rebuilt or recast without touching the whole stack. A cap is a small addition that stops the rain and leaf debris from doing the damage in the first place. Rebuilding is reserved for a stack whose brick and mortar are gone, not for a failed crown. Call (833) 370-3312 for an estimate that separates the two.
Yes, and light burning is a reason to inspect, not a reason to skip it. The bigger risks here are the flue itself and whatever appliance is vented into it, and those don’t care how often you light a fire. A gas furnace flue can fail quietly even with no fireplace use at all. A camera inspection once a year catches the small thing before it becomes a rebuild. Call (833) 370-3312. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
From a repointed crown to a full DuraFlex reline, one call covers the whole chimney: cap, crown, liner, firebox. If you’re in Rhawnhurst and something about your chimney doesn’t look right, call (833) 370-3312 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Tacony.